Finally!!  An OEM solution to tapping into the "blinker circuit" on your Slingshot.  No cutting, no tapping, no splicing.  Just unplug the factory connection and plug in this harness inline on each side.  ALSO, includes (6) 2 terminal lever locks.

Simply lift up on the spring loaded lever lock., insert the stripped wire and snap shut.




This item can be used for all of the following products below:

  • SlingBladez - Power and turn signal connection
  • Dual Color Eyebrows - Power and turn signal connection
  • EyeBladez - Power and turn signal connection
  • Wheel LED's turn signal wire
  • Lower Eyebrow - Positive and negative power


If your connecting more than a couple of items you can add the additional 5 pin lever lock for more connections, see below for options.

Slingshot Blinker OEM Wiring Harness

Choose options

    © 2015-2020  All Rights Reserved

    The manufacturer reserves the right to change/modify product without notice. Actual product may vary in transparency depending on plate color, writing, shade and lighting conditions. NOTE: The manufacturer, retailer, wholesaler assumes no responsibility for any use, misuse or application of this product in violation of any applicable law. Before installing this product, please check your state and local laws and regulations. Use of  any TricLED product is solely used for show purposes, off road purpose only and not to be used in any way that may violate any laws or jurisdiction. TricLed and will not be held responsible from the use or illegal use of such products. Nothing contained herein is intended as legal advice; please seek your local laws and regulation prior to use.