If your adhering anything on porous plastic surfaces such as our LED strips make sure to prep the surface real clean and remove all oily based chemicals.  Prep with alcohol and then use this special primer.  It has been specially formulated to work with the foam adhesive for maximum adhesion on plastics.  To use simply crush at dot and apply on the surface you are prepping, let it dry for 5 minutes and your good to go. 

Plastic Primer Pen


©TricLed.com 2015-2020  All Rights Reserved

The manufacturer reserves the right to change/modify product without notice. Actual product may vary in transparency depending on plate color, writing, shade and lighting conditions. NOTE: The manufacturer, retailer, wholesaler assumes no responsibility for any use, misuse or application of this product in violation of any applicable law. Before installing this product, please check your state and local laws and regulations. Use of  any TricLED product is solely used for show purposes, off road purpose only and not to be used in any way that may violate any laws or jurisdiction. TricLed and will not be held responsible from the use or illegal use of such products. Nothing contained herein is intended as legal advice; please seek your local laws and regulation prior to use.