Talk about simplicity!  These original TricLED design OEM style connectors allows you to simply put this as a bridge in between your motorcycles existing harness.  One female and one male ends allows for easy snap in, non evasive connection.  The extra open end wires allow you to draw power or signal from the factory circuit without ever having to cut, splice or tap into your oem wires.  Terminal ends are supplied with bullet connectors for easy hookup.  All of our light system package are now equipped with these harnesses for easy plug and play installation.

Examples of where these connectors might be used:
Single connector used for rear turn signals on RS/GS
Double connectors used for front turn signal on RS/RT/RT-S
triple connector used to tap into the rear light circuit for running and brakes on the RS/GS
5 pin connector used for RT/RT-S rear running/ brakes and turn signals

OEM Style Connectors

Select Pin Style:
  • Use these to make your life EASY!!!

    Single Pin, Dual Pin, Triple Pin and Five Pin available!!!!

© 2015-2019  All Rights Reserved

The manufacturer reserves the right to change/modify product without notice. Actual product may vary in transparency depending on plate color, writing, shade and lighting conditions. NOTE: The manufacturer, retailer, wholesaler assumes no responsibility for any use, misuse or application of this product in violation of any applicable law. Before installing this product, please check your state and local laws and regulations. Use of  any TricLED product is solely used for show purposes, off road purpose only and not to be used in any way that may violate any laws or jurisdiction. TricLed and will not be held responsible from the use or illegal use of such products. Nothing contained herein is intended as legal advice; please seek your local laws and regulation prior to use.