This OEM style harness is the perfect plug in to the Ryker if your installing any 12V accessory.  Custom made with a wire spliced into the harness to allow for heavier gauge wiring to be used instead of a double pin crimp with thin wiring.  This setup allows for a complete plug and play into the factory open plug just under the left headlight cover.  The male and female end allows for multiple units to be plugged in back to back for convenience.


A 2 pin lever lock and plug in conenctor is included to insert any of your 12V power right into the terminal block.  Connecting 12V power has never been easier.

OEM Accessory harness


    © 2015-2020  All Rights Reserved

    The manufacturer reserves the right to change/modify product without notice. Actual product may vary in transparency depending on plate color, writing, shade and lighting conditions. NOTE: The manufacturer, retailer, wholesaler assumes no responsibility for any use, misuse or application of this product in violation of any applicable law. Before installing this product, please check your state and local laws and regulations. Use of  any TricLED product is solely used for show purposes, off road purpose only and not to be used in any way that may violate any laws or jurisdiction. TricLed and will not be held responsible from the use or illegal use of such products. Nothing contained herein is intended as legal advice; please seek your local laws and regulation prior to use.